Operation procedures
1. Check whether there is dust and foreign matter on the surface of the feeding table panel and sanding roll. After removal, no items are allowed to be placed on the feed port.
2. Check the connection of the suction protection device to confirm its reliability and effectiveness. And do a good job of personal operation protection.
3. Connect the power supply, the air source, the oil quantity of the triple oil mist, drain the water in the filter, the pressure of the air source should be no less than 0.5mpa, according to the processing requirements of the workpiece, choose to install the sand belt with the right number of sand grain. The sand belt should be installed to confirm the running direction of the sand belt and the sand belt back mark is consistent, never use the sand belt with scratches or cracks, after the installation of the sand belt, check the sand belt anti-channeling device, should be firmly locked, open the sand belt expansion switch, and close the safety door.
4. Start the vacuuming device first, then start the sand roll switch, and finally start the conveyor belt and polishing wheel switch after the sand roll runs normally.
5, is not allowed to process too small or too large beyond the scope of equipment processing workpiece, workpiece feed speed and processing amount to determine according to the specific situation, can not be overspeed boot, can not be in a single processing amount is too large in the case of boot.
Daily maintenance and standard
1. Conveyor belt tension moderate, no deviation monthly check, adjustment.
2. Check and adjust the height of both ends of the workbench monthly.
3. Suitable oil level of transmission and no shortage of oil. Check weekly, add timely, replace the new oil once every six months
4 Roller end bearing lubrication, no noise, flexible activity, check once a week, add butter
